DX53D | 1.0951

Grade DX53D is a deep-drawing grade that meets high demands on formability and is particularly suitable for the production of difficult profiles with greater thicknesses.

DX53D - send request!

Low-carbon steel for cold forming

Properties according to DIN EN 10 346

Steel type

Short designation	VDA239-100*	Surface finish	Material number
DX53D	CR2	+Z,+ZF,+ZA,+ZM,+AZ,+AS	1.0951

* Comparative grade, therefore minor deviations from DIN EN values possible

DX53D | 1.0951: Mechanical properties (transverse)

Yield strength ¹⁾ Re MPa max.	Tensile strength Rm MPa	Elongation at ²⁾ fracture A80 % min.	Anisotropy r90 min.	Strain hardening exponent n90 min.
140–260	270–380	30	-	-

DX53D | 1.0951: Chemical composition (heat analysis)

Percentage by weight % max.
C	Si	Mn	P	S	Ti
0.12	0.50	0.60	0.10	0.045	0.30

Your product of choice: DX53D | 1.0951

Send request!

1) Where no yield strength is defined, the respective values shall apply to the 0.2 % proof stress Rp0.2, otherwise for the lower yield strength (ReL).

2) Reduced minimum values of elongation at fracture apply to product thicknesses 0.50 mm < t < 0.70 mm (minus 2 units), 0.35 mm < t < 0.50 mm (minus 4 units), and t < 0.35 mm (minus 7 units).