DC04 | 1.0338

Grade DC04 is a deep-drawing steel of the DC grade family. The grade has excellent deep-drawing properties under all types of deformation. DC04 is suitable for high forming requirements.

DC04 – send request!

Mild low-carbon steel for cold forming

DC04 | 1.0338: Properties according to DIN EN 10 130

Steel type

Short designation	VDA239-100*	Material number
DC04	CR3	1.0338

* Comparative grade, therefore minor deviations from DIN EN values possible

DC04 | 1.0338: Mechanical properties (transverse)

Yield strength¹⁾ Re MPa max.	Tensile strength Rm MPa	Elongation at fracture²⁾% min. A80	Anisotropy r90³⁾⁴⁾min.	Strain hardening exponent n90³⁾min.
210	270-350	38	1.6	0.180

DC04 | 1.0338: Chemical composition (heat analysis)

Percentage by weight % max.
C	P	S	Mn	Ti
0.08	0.030	0.030	0.40	-

Your product of choice: DC04 | 1.0338

Send request!

1) Where no yield strength is defined, the respective values shall apply to the 0.2 % proof stress (Rp0.2) or to the lower yield strength (ReL). For thicknesses ≤ 0.7 mm but > 0.5 mm, the maximum yield strength values may be 20 MPa higher. In case of thicknesses ≤ 0.5 mm, the maximum yield limits may be 40 MPa higher.

2) For thicknesses ≤ 0.7 mm but > 0.5 mm, the minimum elongation at fracture may be 2 units lower. For thicknesses ≤ 0.5 mm, the minimum elongation at fracture may be 4 units lower.

3) The r90 and n90 values apply to product thicknesses ≥ 0.5 mm only.

4) For thicknesses > 2 mm, the r90-value is reduced by 0.2.